Safety Instructions; Instructions For Assembly, Mounting And Use - hawa 6319-3010-00-01 Instructions De Montage

Scope of delivery:
1 hood
1 hood holder
exhaust filter
Drilling template DIN A2
Spare parts:
Filter pad depending on the size (10 pieces)
A= 92
A= 125
A= 177
A= 223
A= 291
All specified details apply to the filter hood without further processing.

Safety Instructions

Please observe the instructions on foreseeable misuse and residual risks as well as the special instructions and technical data specified on
pages 7 to 9 of this manual to reduce danger to life and limb to a minimum.
Please note the standards and regulations applicable to your industrial control panel enclosure / your low-voltage switchgear and control-gear assembly.
- Make sure that the control cabinet is disconnected from the power supply and secure it against accidental unintentional energizing.
- For all transport including moving to the installation site and unpacking as well as the mounting, ensure that the product is neither damaged nor rendered
unserviceable.
- Use suitable climbing aids adapted to the working height.
- Observe the torque specifications.
- Only use the supplied mounting hardware to ensure the potential equalization.
- Avoid static and dynamic loads.
Foreseeable Misuse, Residual Risks
- Use of unsuitable tools and incorrect mounting hardware
- Insufficient qualification of staff
- Visual inspections and functional tests are not carried out

Instructions for Assembly, Mounting and Use

- Please observe the mounting order specified in heading Mounting.
- When using climbing aids and/or handling large or heavy parts, check if the assistance of a second person is useful or necessary.
- Please check the product for completeness – see scope of delivery.
- Please check the product for damage before installation.
- Please clean dirty enclosures.
- For detailed information about positioning and alignment of the hood, see mounting instructions.
Special instructions for the mounting of filter hoods to third-party enclosures
- Please ensure that the enclosure door or side panels are sufficiently reinforced to support the weight of the hood.
- The enclosure must have a minimum material thickness of 1,5 mm.
1 set mounting hardware for hood holder
4 cap nuts M4
7mm wrench (width across flats)
Order no.
3156-9003-10-00-00
3156-9003-15-00-00
3156-9003-20-00-00
3156-9003-25-00-00
3156-9003-30-00-00
7