VOLTCRAFT VC-CJS10 Mode D'emploi page 3

Operating Instructions
VC-CJS10 Power Bank Quick Start System 1200 A
Item no: 2353911
1 Intended use
The product is a power bank and quick start system for petrol and diesel engines.
It has an integrated LED light.
Important:
The product has an IP67 ingress protection rating and is protected against dust and water sprayed
from any direction. It is only protected when the sockets cover is closed.
Contact with moisture must be avoided under all circumstances if the sockets cover is open.
If you use the product for purposes other than those described, the product may be damaged.
Improper use can result in short circuits, fires, electric shocks or other hazards.
The product complies with the statutory national and European requirements.
For safety and approval purposes, you must not rebuild and/or modify the product.
Read the operating instructions carefully and store them in a safe place. Make this product available to
third parties only together with the operating instructions.
All company names and product names are trademarks of their respective owners. All rights reserved.
2 Delivery contents
■
Product
■
"Smart" starter cables
■ TM
USB-C to USB-A charging cable
■
TM TM
USB-C to USB-C charging cable
■
Carry pouch
■
Operating instructions
3 Latest product information
Download the latest product information at
low the instructions on the website.
4 Description of symbols
The symbol with the exclamation mark in the triangle is used to indicate important informa-
tion in this document. Always read this information carefully.
Risk of electric shock!
The arrow symbol indicates special information and advice on operation.
5 Safety instructions
Read the operating instructions carefully and especially observe the safety informa-
tion. If you do not follow the safety instructions and information on proper handling,
we assume no liability for any resulting personal injury or damage to property. Such
cases will invalidate the warranty/guarantee.
5.1 General
■
The product is not a toy. Keep it out of the reach of children and pets.
■
Do not leave packaging material lying around carelessly. This may become dangerous playing mater-
ial for children.
■
If you have questions which remain unanswered by this information product, contact our technical
support service or other technical personnel.
5.2 Connected devices
■
Also observe the safety and operating instructions of any other devices which are connected to the
product.
5.3 Handling
■
If it is no longer possible to operate the product safely, take it out of operation and protect it from any
accidental use. Safe operation can no longer be guaranteed if the product:
– is visibly damaged,
– is no longer working properly,
– has been stored for extended periods in poor ambient conditions or
– has been subjected to any serious transport-related stresses.
■
Handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.
■
Consult an expert when in doubt about the operation, safety or connection of the appliance.
5.4 Operating environment
■
Do not place the product under any mechanical stress.
■
Protect the appliance from extreme temperatures, strong jolts, flammable gases, steam and solvents.
■
Protect the product from high humidity and moisture.
■
Protect the product from direct sunlight.
5.5 Li-ion battery
■
The rechargeable battery is permanently built into the product and cannot be replaced.
■
Never damage the rechargeable battery. Damaging the casing of the rechargeable battery might
cause an explosion or a fire!
■
Never short-circuit the contacts of the rechargeable battery. Do not throw the battery or the product
into fire. There is a danger of fire and explosion!
■
Charge the rechargeable battery regularly, even if you do are not using the product. Due to the re-
chargeable battery technology being used, you do not need to discharge the rechargeable battery
first.
■
Never charge the rechargeable battery of the product unattended.
3
www.conrad.com/downloads or scan the QR code shown. Fol-
■
When charging, place the product on a surface that is not heat-sensitive. It is normal that a certain
amount of heat is generated during charging.
5.6 LED light
■
Do not look directly into the LED light!
■
Do not look into the beam directly or with optical instruments!
5.7 Product
Explosion Hazard! Do NOT use this product where flammable fumes or gases may be present, e.g. Petrol
refueling station.
6 Product overview
Important:
For the ingress protection rating to be effective, the sockets cover must be closed.
6.1 Product
1 2 3
4 5
1 LED light
3 Starter cables socket
5 Charging input / Charger output: USB-C™
6.2 Starter cables
A
B
C
E
A Starter status indicator
C Force start button
E Black starter clip (-)
7 Charge the product battery
Important:
– Do not charge the power bank using the USB-A ports on a computer. The current supplied by
these ports may not be sufficient and can damage the computer.
– To prolong the battery life, it is recommended to fully charge the battery every 3 - 6 months.
– Do not jump start the vehicle while charging the batteries!
■
The battery level indicators will indicate the level of charge: (● = 25%, ●● = 50%, ●●● = 75%,
●●●● = 100%).
■
Short press the Power button to check the battery level.
■
To recharge the battery, connect one end of the charging cable to a power supply and the other end
to a charging input on the product.
– Battery level indicators flashing: charging in progress
– Battery level indicators constant on: fully charged.
8 Power bank
P :
RECONDITIONS
a
To use this product as a power bank you will need a suitable charging cable.
1. Connect one end of the charging cable to your mobile device, and the other end to a charger output
on the product.
2. Press the Power button to start charging.
9 LED light
1. Press and hold the Power button (approx. 3 secs) to switch the LED ON/OFF.
2. Press the Power button repeatedly to cycle through modes: constant ON → SOS → flashing →
OFF.
6
2 Charger output: USB-A
4 Charger output: USB-A
6 Charging input: Micro-USB
D
B Starter cables plug
D Red starter clip (+)