KEUCO Plan 33096 111050 Instructions D'utilisation page 3

US
Read all instructions before using or installing this product.
Technical data
– Supply voltage:
– Required electrical outlet:
– Max. power consumption:
Prod. No.:
33096 XX1050:
– Degree of protection:
– Ambient conditions:
Operating temperature
Storage temperature
– Luminous color
Mounting dimensions, see page 10.
Modes
The device can be operated in two modes.
Mode 1 (ex works):
Lighting On/Off at the device button (Off
automatically after power returns).
Mode 2:
Lighting On/Off at the external light switch (Off
automatically after power returns).
To change mode, see table under Operation:
Installation, see fi gure 1 onwards on page 11.
Before installation check whether the fastening mate-
rials included are suitable for the anchoring base. The
fastening materials are suitable exclusively for stud walls
with timber constructions or for drywall constructions
with timber wood reinforcement.
• Mark the wall bracket position, see fi gure 1.
• Mount the wall brackets to the wall, see fi gure 2.
• Mount the light mirror fi xation, see fi gure 3.
Wiring diagram, see fi gure 4 on page 12.
• Connect the light mirror to the power supply,
see fi gure 5.
WARNING - GROUNDING
INSTRUCTIONS
This product must be connected to a grounded me-
tal, permanent wiring system, or an equiment-groun-
ding conductor must be run with the circuit con-
ductors and connected to the equipment-grounding
terminal or lead on the product.
• Remove the adhesive cover from the light mirror
fi xation, see fi gure 6.
• Hang the light mirror on the wall from above,
see fi gure 7 on page 13.
• Press the light mirror to the light mirror fi xation,
see fi gure 8.
120 V AC / 50/60 Hz
15 A / 1800 VA
Width Weight Light
18 W
18-1/8" 21.83 lb
NEMA 1
32° – 113° F
-40° – 158° F
3000 Kelvin
Operation
Button functions
Button Function
Light on/off
• Pressing the button switches the light mirror
on with the selected settings. The white LED
goes off.
• Pressing the button again switches the light
mirror off. The white LED lights up.
To change mode
• Switch off the refl ector.
• Press the button and hold it down for 15
seconds.
- A short light impulse indicates that the
mode has been changed.
Repeat the procedure described to re-enable
mode 1.
• The white LED can be deactivated.
– Switch on the light mirror.
– Press and hold the button for 15 seconds.
- The lighting gets lighter or darker.
- The lighting switches off briefl y and the
white LED is deactivated.
To switch the white LED back on, repeat the
described procedure.
Front and wall lighting
• The front and wall lighting is switched on
by pressing the button when light mirror is
switched on.
• Pressing the button again switches the light
off.
Washbasin lighting
• The washbasin lighting is switched on by
pressing the button when light mirror is
switched on.
• Pressing the button again switches the light
off.
When both lightings are switched off, the light
mirror also switches off.
Dimming the front, wall and washbasin
lighting
• Press the button when the light mirror is
switched on and hold until the desired bright-
ness or the end value has been reached.
The setting is stored and reproduced when
switched on again (only for connection type 1,
see fi gure 4 on page 12).
Replacement parts with order numbers, see page 15.
The light sources may only be replaced by the
manufacturer, its customer service or by an
equally qualifi ed person.
For information about warranty and mainte-
nance, see the enclosed Care Instructions
and Warranty Card.
3