Camera Programming - Stealth Cam Trail Hawk Serie Manuel D'instructions

The Trail Hawk Series features 2 distinct modes of operation: QSET / CUSTOM. Each
setting is activated based upon the position of the program switch on the inside of
the unit.
QSET – This is the Quick Set programming mode. When the camera is changed to the this mode,
the display screen will give a digital read out of the following:
With this setting the camera is preprogrammed to take photos at MED resolution, a 30 second
timeout delay between activations and takes 1 photo every trigger activation.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING
st
1 - dLY 30 – (Delay) Counts down from 9sec to 0sec
- rdY – (Ready) Camera is in a ready and active state
nd
2
8
Page