Battery Removal & Installation - Stealth Cam Trail Hawk Serie Manuel D'instructions

BATTERY REMOVAL & INSTALLATION
To remove the batteries; open the battery door and slide the batteries out.
New, Alkaline or Lithium, 'AA' batteries must be inserted with the orientation as shown in the
compartment. As with most electronic devices the negative ( - ) orientation of the batteries
should be against the springs. Failure to insert the batteries properly will cause damage to the
unit.
Once batteries are properly installed and with the orientation correct, simply close the
battery compartment door back into its final locked position. Should the battery door not
willingly latch into it destination, remove the batteries and examine the area of possible
debris that may be causing the issue.
NOTE: Replacing the batteries will not reset the cameras current configurations.
**WARNING**
Do not mix new and old batteries.
Remove batteries from the tray if the unit will not be in use for extended period of time.
14
www.stealthcam.com Page
877-­‐269-­‐8490