Quick Diagnostics - Whirlpool W10441082B Manuel D'instructions

FOR SERVICE TECHNICIAN'S USE ONLY
QUICK DIAGNOSTIC TEST
NOTE: The Service Diagnostic mode must be
activated before entering the Quick Diagnostic
Test; see procedure on page 4. If, at any point,
the user presses the POWER button, the
washer exits to standby mode.
Active Fault Code Display
in Quick Diagnostic Test
If the display begins flashing while in the Quick
Diagnostic Test, it is displaying an active fault
code. Active fault codes are codes that are
currently detected. Only one active fault code
can be displayed at a time.
i Press power button at any time to exit i
TEST
WASHER FUNCTION
PHASE
C00 Door lock motor is actuated. Door
or C0 unlocks, and then locks again.
Pump is activated for 15 seconds.
C01* Heater is turned on for 1 min.
or C1 Steam valve is actuated.
C02 Cold 1 valve will actuate (through
or C2 Detergent dispenser) for 40 secs.
C03 Cold 2 valve will actuate (through
or C3 Fabric Softener dispenser) for 40 secs.
C04 Hot 1 valve will actuate (through Main
or C4 Wash dispenser) for 40 secs.
C05 Drum rotates clockwise at wash speed
or C5 for 20 secs.
C06* Heater is turned on to heat water
or C6 to pre-set temperature level.
Drum rotates clockwise and counter-
clockwise at wash speed for 1 min.
Water valve is activated to fill drum
to minimum water volume required
to wash. (If there is enough water
in the drum, the water valve will not
turn on.)
C07 Drain Pump is actuated until there is no
or C7 water in the system—plus an additional
15 seconds.
C08 Drum rotates counter-clockwise at
or C8 maximum speed.
Door lock motor is actuated. Door
unlocks.
QUICK DIAGNOSTIC TEST NOTE:
*C01, C06 – Valve name and location can be found in TEST #6: Water Inlet Valves, page 17. Some models may not have steam and/or heater.
PAGE 6
Entry Procedure
To enter the Quick Diagnostic Test, press and
release the 2nd button used to activate the
Service Diagnostic mode. The power button
indicator turns on and the start button indicator
begins to flash. Press the START button to
perform the Quick Diagnostics tests listed below.
Each test phase is indicated on the display.
IMPORTANT: If entry into Quick Diagnostics
is performed too quickly after activating the
Service Diagnostic mode, the test will not start.
Exit Procedure
To exit Quick Diagnostics, press the POWER
button, or press and hold the 1st button used
to activate Service Diagnostic mode for 5
seconds.
QUICK DIAGNOSTIC TEST
COMPONENT
• Door Lock System
• Drain Pump
• Heater
• Steam Valve
• Temperature Sensor
• Cold 1 Valve
• Cold 2 Valve
• Hot 1 Valve
• Motor
• Heater
• Temperature Sensor
• Motor
• Cold 1 Valve (if needed)
• Water Level Sensor
• Drain Pump
• Water Level Sensor
• Motor
• Door Lock System
PHASE ENDS...
on completion ONLY.
on completion or START key press.
on completion or START key press.
on completion ONLY.
on completion or START key press.
on completion or START key press.
on completion or START key press.
on completion or START key press.
on completion or press of the
POWER button.
DO NOT REMOVE OR DESTROY