Directions For Use - Guardian Technologies H1510 Utilisation Et Instructions D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DIRECTIONS FOR USE

SET UP
Select a firm, level, flat location - at least six inches (15 cm) from any wall or object for proper air flow.
Place the humidifier on a water-resistant surface, as water can damage furniture and some flooring.
Do not place unit directly on carpet, towels, blankets or other absorbent surfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
FILLING -
Make sure unit is unplugged.
1. Separate the tank from the base of
the unit.
3. Pour cool, clean water directly into
the tank. Do not pour anything but
water into the tank.
5. Attach tank to base of unit and plug in
E-6
2. Flip over water tank and open the
tank lid, turning it to the left
4. Close the tank lid, turning it to the right.
It is important to FIRMLY secure cap
after filling the tank with water.
COOL
OFF
WARM
POWER
6. Power Button
Before turning on make sure there is
water in the unit. Turn the Power button.
DIRECTIONS FOR USE
CONTROL OPERATION
LIGHT
NO WATER
1. Night Light Feature
Turn Night Lamp dial to illuminate the
night light.
COOL
OFF
WARM
POWER
3. Cool or Warm Humidification Indicator
Select cool or warm mist. Water
temperature is maintained at room
temperature for cool setting and
80 degrees for warm. Allow 15 minutes
for water to warm.
Rotates
separately
5. Humidity Spout Dual Direction
Broaden mist in two different
directions throughout the room
by rotating top section.
2. Variable Mist Control Dial
Turn the Mist Control dial to select
the amount of mist you prefer.
LIGHT
NO WATER
4. Water Refill Indicator
When the unit is low on water the Refill
LED on the front panel will light up, and
the unit will shut off. Simply add more water
to continue use. Unit will automatically resume
running when water tank has been refilled.
E-7

Publicité

Table des Matières
loading

Table des Matières