Directions For Use - Guardian Technologies Easy Top Fill Utilisation Et Instructions D'entretien

SPECIFICATIONS
HUMIDIFYING MODE: Ultrasonic Cool Mist
SUCCESSIVE HUMIDITY HOURS: Up to approximately 90 hours between tank
refills when on lowest mist setting.
PARTS
Mist Spout
Lid
Empty
Spout
Tank
Base
Power
Plug
Power
Refill
Variable Speed Dial
Indicator LED

DIRECTIONS FOR USE

SET UP
Select a firm, level, flat location - at least six inches (15 cm) from any wall or object for proper air flow.
Place the humidifier on a water-resistant surface, as water can damage furniture and some flooring.
Do not place unit directly on carpet, towels, blankets or other absorbent surfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
FILLING -
Make sure unit is unplugged.
1. Remove
the tank lid.
E-4
TANK CAPACITY: 1.5 gallons
Mist Outlet
Cleaning Brush
Mist Tube
Essential Oil
Tray and Pad
SILVER CLEAN TECHNOLOGY
™
Silver Clean technology is embedded in the
™
tank to fight the growth of mildew and mold on
the surface of the water tank.
Night Light Control
2. Pour cool, clean water
directly into the tank using
a water pitcher. Fill to-max-
line on Mist Tube.
MA X
3. Return the tank lid.
7. Add a few drops of your favorite essential
oil to the pad in the tray. (Oil not included)
WARNING: DO NOT add oils or other additives
directly into the water tank. Add only to the pad
in the tray. Oils added to the tank will damage the
tank and the whole unit. Any use of such additives
in the tank will void the manufacturers warranty.
Pureguardian essential oils and replacement pads
sold separately at www.guardiantechnologies.com
CLEANING
1. Always unplug the unit before servicing in any way.
GENERAL CLEANING
2. Water tank. Remove the mist tube by rotating it
counter clockwise. Empty the tank by pouring all
the water on the left side (see arrow inside tank).
Clean the mist tube with fresh water and a light brush
(bottle cleaning brush is recommended). Return mist
tube after cleaning. Turn clockwise to lock.
3. Outer surface of the unit. Wipe the lid and surface
of the unit with a soft, damp cloth if needed. If you notice
an accumulation of water during usage, reduce humidity
and dry outer surface with a cloth.
NIGHT LIGHT
4. Plug-in unit and rotate control to power on.
5. Select desired mist volume.
6. Select night light ON/OFF.
LED LIGHT
8. WATER REFILL INDICATOR
When the unit is low on water the LED turns
BLUE to RED and the unit will shut off. Simply
add more water to continue use. Unit will
automatically resume running when water tank
have been refilled.
E-5