FONESTAR DMX-83 Mode D'emploi page 9

ADD ONE STEP TO ANOTHER ALREADY CREATED IN A CHASE
- In programming mode, select the chase you want to edit with the CHASE 1-6 buttons.
- Press the DISPLAY/TAPSYNC button and the total number of scenes will be displayed.
- Find the step before the desired location for the new step using the BANK UP and BANK DOWN buttons.
- Pulse el botón ADD para añadir un paso en blanco donde almacenar la escena nueva.
- Select the bank where the scene you want to add to the chase is located using the BANK UP and BANK
DOWN buttons.
- Press the SCENES 1-8 button for the corresponding scene be stored in this newly created step.
- Press the ADD button to record the scene in the STEP. All LEDs will flash three times indicating that
programming has been completed successfully.
- Repeat the above steps to add as many scenes to a chase as you want.
- Exit programming mode. The BLACKOUT feature is automatically activated.
Examle: To store the new scene between two specific positions, for example, between 5 and 6, you must
press the ADD button when the display shows scene 005. Pressing this button on the screen will show the
number of the empty scene increased by one unit, in our case it would show 006, indicating that the empty
scene was then created between positions 5 and 6.
COPY AN ENTIRE BANK AT THE END OF A CHASE
- Within programming mode, select the bank you want to add to the chase using the BANK UP and BANK
DOWN buttons.
Please note that the 8 bank scenes will be stored at the end of the programming of the current chase.
- Select the chase you want to edit with the CHASE 1-6 buttons.
- Press the ADD and MUSIC/BANK COPY buttons simultaneously to store the programming within the chase.
All LEDs will flash three times indicating that programming has been completed successfully.
- Repeat the above steps to add as many banks to a chase as you want.
- Exit programming mode. The BLACKOUT feature is automatically activated.
ELIMINATE ONE STEP OF A CHASE
- In programming mode, select the chase you want to edit with the CHASE 1-6 buttons.
- Press the DISPLAY/TAPSYNC button and the total number of scenes will be displayed.
- Find the location of the scene to be deleted using the BANK UP and BANK DOWN
- Press the AUTO/DEL button to delete the scene All LEDs will flash three times indicating that scene has
been deleted successfully.
- Repeat the above steps to delete as many scenes as you want.
- Exit programming mode. The BLACKOUT feature is automatically activated.
ELIMINATE A CHASE
- In programming mode, select the chase you want to delete with the CHASE 1-6 buttons.
- Hold down the AUTO/DEL button and, without releasing it, press the button corresponding to the chase
to be deleted (CHASE 1-6). All LEDs will flash three times indicating that the chase has been successfully
deleted.
- Repeat the above steps to delete as many chases as you wish.
- Exit programming mode. The BLACKOUT feature is automatically activated.
- 9 -
EN
buttons.