AUTO-HAK F25 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
13
16
A
7
5
16
10
9
This towbar is designed to assembly in following cars:
PEUGEOT 307 Brea/SW (ESTATE), produced since 03.2001 till 06.2005
and since 06.2005 till 03.2008, catalogue number F25 and is prepared to
tow trailers max total weight 1500 kg and max vertical load 60 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
6
1
20
8
21
2
3
From manufacturer
1. Disassemble handles of the bumper.
2. Put brackets of the towbar on chassis member pins and fix loosely:
- Left side element signed F 25 L (pos. 5),
A
- Right side signed F 25 P (pos. 4).
4
3. Slide the bar of towbar between brackets and fix it with M12x35mm (pos. 9).
4. Put handles (pos. 6 and 7) on pins placed at the side of the chassis member and
on brackets (pos. 4 and 5) holes (pos. A), then fix it as it shown fig 1.
5. Cut the handle of the bumper according to fig. 2 (if necessary).
6. Position the ball of towbar (pos. 2) and fix with M12x70mm bolts (pos. 8) and
nuts from the towbar accessories.
7. Fix the socket plate (pos. 3) as shown on the drawing.
9
8. Tighten all nuts and bolts according to the torque shown in the table.
9. Connect the electric wires according to the instructions of the car.
10. Complete the paint cover of towbar (during the mounting paint cover could be
destroyed).
24
3
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book
(at authorised service station). The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar
must be always kept clear and conserve with a grease.
The instruction of the assembly
cut out
2
1
handles
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
10
Fig.2
M10 - 50 Nm
M16 - 210 Nm