Russell Hobbs FP3100 Mode D'emploi page 6

A
USING THE PROCESSOR
The general assembly steps are shown in figure A.
1. Fit the spindle to the top of the motor unit.
2. Lower the workbowl on to the motor unit, then turn it clockwise to lock it
in place.
3. Fit the drive shaft.
4. Fit the chopping blade or the dough tool.
5. Put the ingredients into the workbowl.
6. Hold the lid with the tube slightly behind the workbowl handle, set it on
the workbowl, then turn it clockwise to lock the tab into the top of the
handle.
Once finished, switch the appliance off O and unplug it.
7.
8. Turn the workbowl counter-clockwise, and lift it off the motor unit.
• To add ingredients while the motor is running, lift the pusher out of the
tube, add the ingredients through the tube then replace the pusher.
• To remove the lid, turn it counter-clockwise to unlock it, then lift it off.
6