PROEL FREEPACK65 Notice D'utilisation page 13

6. HIGH tone control
This control boosts or cuts the high frequencies with a "SHELVING" curve shape. Use it to increase or reduce the sound
"clarity" or "brightness".
7. LOW tone control
This control boosts or cuts the low frequencies with a "SHELVING" curve shape. Use it to increase or reduce the sound
"punch".
8. FX level control
This control sets the level of the signal sent to the internal digital mul eff ect processor.
9. MONITOR level control
This control sets the level of the signal sent to the MON output (see also AMP MODE se ng).
10. MIC/LINE Input
This is a COMBO female connector, which accepts balanced or unbalanced signals from a XLR connector of almost any
type of microphone or a ¼" (6.3mm) jack connector of almost any source with line level signal.
The XLR input is wired as follows:
Pin 1 = shield or ground
Pin 2 = + posi ve or "hot"
Pin 3 = - nega ve or "cold"
The JACK input is wired as follows when connec ng a balanced signal:
Tip = + posi ve or "hot"
Ring = - nega ve or "cold"
Sleeve = shield or ground
or as follows when connec ng an unbalanced signal:
Tip = + posi ve or "hot"
Sleeve = shield or ground
11. RCA LEFT/RIGHT input B
These are two female RCA connector, which accept an unbalanced line level input signal from almost any source.
12. MINI-JACK input A
This is a stereo MINI-JACK connector, which accept an unbalanced line level stereo signal from almost any source.
13. INPUT A/B bu on
It selects the signal from A or B input and send it to the CHANNEL 8 LEVEL control.
14. CHANNEL 8 LEVEL control
Adjusts the level of the channel 8 signal.
15. RIGHT/MON LEVEL control
The RIGHT/MON LEVEL controls the output level just before the SPEAKER, PRE-AMP and REC outputs. It adjust the
general level of the RIGHT output or the MONITOR output depending on AMP MODE switch se ng.
16. LEFT/MAIN LEVEL control
The LEFT/MAIN LEVEL controls the output level just before the SPEAKER, PRE-AMP and REC outputs. It adjust the general
level of the LEFT output or the MAIN output depending on AMP MODE switch se ng.
17. AMP MODE switch
The AMP MODE switch select the output signal of SPEAKERS, PRE-AMP and REC outputs.
In the UPPER posi on both LEFT and RIGHT output signals are controlled only by the CHANNEL level controls.
In the LOWER posi on the LEFT/MAIN output signal is controlled by the channel level controls, while the RIGHT/MON
output signal is controlled by the MONITOR level controls.
18. FX ON switch
This switch turns on the internal DIGITAL MULTIEFFECT.
19. FX rotary selector
Use the FX rotary selector to choose the eff ect you want to use:
PLATE 1, ROOM 1, PLATE 2, PLATE 3, ROOM 2, ROOM 3, HALL 1, HALL 2, DELAY 1, DELAY 2, FLANGE, CHORUS, CHORUS
/ROOM 1, CHORUS/ROOM 2, VOCAL CANCEL, ROTARY SPEAKER.
20. FX LEVEL control
Adjusts the level of the internal eff ect sent to the MAIN outputs.
21. PARAMETER control
It adjust the amount of most important parameter of the selected eff ect.
13