Kingston Technology DataTraveler 6000 Mode D'emploi page 14

3. Create a password to protect your data on the DT6000. Enter it in the ‘Password'
field, then re-enter it in the ‘Password Confirmation' field, as seen below in
The password you create must meet the following criteria before the initialisation process
will allow you to continue:
1. Passwords must contain 8 characters or more (up to 128 characters).
2. Passwords must contain three (3) of the following:
- UPPER CASE, lower case, numeric and/or special characters (!, $, etc.)
You may also enter a password hint, but it is not a mandatory field. The hint field can be
useful in providing a clue as to what the password is, should the password ever be
forgotten. (Note: The hint CANNOT be an exact match to the password.)
Document No. 48000191-001.A00
Figure 7.3 – Password setup
®
DataTraveler 6000
.
Figure 7.3
Page 13 of 21