Inputs And Outputs; Sms Outputs (Sms1 - Sms4) - Conrad Electronic GX106 Notice D'emploi

Inputs and outputs

ATTENTION:
This alarm message device works autonomously. Wrong settings or
connections may lead to unwanted SMS dispatch!
Possible errors are, for example:
- the applied voltage on IN1 or IN2 is exactly on the switching
threshold of the two optocouplers;
- the applied voltage on the ADC fluctuates by the set limit value;
- the temperatures on the T1 or T2 fluctuate by the set limit value
Under no circumstances enter the telephone number of the SIM
card used in the module! Otherwise, the module will send an SMS to
itself in case of a switching operation. As soon as this SMS is
received, a response is generated and so on!
With this module, you can send a switching message to another
module. Therefore, "response" may not be activated on the receiv-
ing device!
At the start, connect the PC, test the desired functions and monitor
all messages in the software's STATUS display!

4 SMS OUTPUTS (SMS1 - SMS4)

These are the four outputs SMS1 to SMS4 that can be activated/deacti-
vated by sending an SMS or e-mail to the module. A relay is already con-
nected to the output SMS1. You can directly connect a relay to the oth-
er outputs (CONRAD order no. 502892). This relay can switch 8 Ampere
at 250V AC or 5 Ampere at 30V DC.
For each of the four outputs, you can assign a (different)
message texteach. This text serves to address the output. For switch-
ing, the SMS or the e-mail contains the message text of the respective
output with the appendix =1 for activating or =0 for deactivating. For
activation, e.g. RELAY =1 and for deactivation RELAY1 =0 is sent.
40