Install Shelves; Install Doors - Whirlpool GLADIATOR GARAGEWORKS GAWG28KDYG Instructions D'assemblage

4. Completely tighten all back panel screws starting with the sides
and continuing with the top, middle and bottom.
5. Using the Allen wrench (provided), completely tighten all the
cabinet bolts and nuts.

Install Shelves

F3b F4
F3b Phillips-head screw (8)
F4 Small flange nut (8)
IMPORTANT: Install the lower shelf, using the second set of holes
from the bottom, so the doors will close and lock. The other shelf
may be installed where desired.
1. Align the holes in the ends of the lower shelf (P6) with the holes in
the cabinet side (P1) that are second from the bottom.
NOTE: Make sure the hole in the center of the long edge is facing
out.
2. Using two Phillips-head screws (F3b) and two small flange
nuts (F4) per side, attach the shelf (P6) to the sides (P1).
3. Insert the door catch pin (F5) into the hole in the front edge of the
lower shelf and fasten it with the star nut (F6) as shown.
P2
P1
A
A. Second set of holes from the bottom
B. Door catch pin and star nut
4. Determine where you want to place the upper shelf (P6) and align
the holes in the ends of the shelf with the holes in the sides.
NOTE: Make sure the hole in the center of the long edge is facing
the back panel.
5. Using two Phillips-head screws (F3b) and two small flange
nuts (F4) per side, attach the shelf to the sides (P1).
6. Completely tighten the screws.
4
F5 F6
F5 Door catch pin (1)
F6 Star nut (1)
P1
P6
P3
IMPORTANT: The door with the lock assembly should be installed on
the right-hand side of the cabinet.
1. Align three holes in the right-hand door hinge (P7) with the three
holes in the right-hand side.
NOTE: There are two holes in the middle of the door hinge. Align
the top and bottom holes first. Only one of the middle holes will
align.
2. Using three Phillips screws (F3b), starting with the top hole,
attach the door (P7) to the side (P1) as shown. Do not tighten
completely.
B
3. Repeat Steps 1 and 2 to attach the left-hand door (P8).
4. Align the doors and completely tighten the screws.

Install Doors

F3
F3b Phillips-head screw (6)
P2
P6
P6
P7
P1
P3