Adjust Shelves - Whirlpool GLADIATOR GAWG241DRG Instructions D'assemblage

4.
Inspect the cabinet from the sides
Inspect the cabinet from the sides to ensure both the top
and bottom wall-mounting brackets are fully engaged in their
respective slots as shown.
1.
Remove the shelves
B
Remove the shelf clips from their shipping position on the sides
and rear of the cabinet. Working from the inside of the cabinet
and using a blunt tool, push out the plastic shelf clips. Discard the
clips. Lift up on the underside of the shelf until the shelf tabs are
free of the cabinet slots. Tilt the shelf up to reposition it within the
cabinet or to remove it from the cabinet.
25-Feb-2021 08:06:20 EST | RELEASED
A. Push down
B. Lift up
A
A. Remove the shelf
In some European factories the letter "W" of the part code mentioned herein will be automatically
5.
Install cabinet to a standard wall
IMPORTANT: The round holes in the top and bottom cabinet
back panels are spaced 8" (20.32 cm) apart to allow you to mount
the wall cabinet to your garage wall studs. Locate the wood studs
in your garage wall. Align two holes at the top and two holes at
the bottom with the wood studs, and mark the location of the
holes. While two or more people hold the cabinet against the wall,
attach the wall cabinet to the garage wall using 1/4" flat washers
and 1/4" – 20 x 11/2" Lag screws (not provided). Using a 7/16"
wrench, fully tighten the screws.

Adjust Shelves

2.
Replace the shelves
A
B
NOTE: Plan your shelf heights and install shelves starting from
the bottom. The shelves are supported by the metal tabs on the
back and side walls of the cabinet. Determine the placement of
the shelves. Tilt the shelf so that one end is higher than the other
as shown. Insert the shelf into the cabinet so that the higher end
is directly above the desired slots and push the shelf down in
place behind the side slots. Raise the lower end so it is directly
above the desired slots and push the shelf down.
NOTE: Make sure the shelf tabs are in place behind all the slots,
as shown. Repeat this process for the other shelf.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
A
A
A. Holes for standard wall mounting
A
A. Insert the shelf
A
A
A. Slot
B. Shelf tab
B
A. Push down
B. Lift up
5