Table des Matières
Publicité
STEP 4 - Hub initialisation
When the hub powers up, you will see a sequence of flashing LEDs on the
front.
Pair your remote by holding the 'Remote pair' button on your remote until
the remote LED on the hub stops flashing and turns solid white (ensure 2 x
AAA batteries supplied are fitted).
Remote pair
After three minutes the flashing LED's will stop and you will be left with a
solid red LED next to the Standby button.
If a solid red LED is not shown please refer to the full manual available
on-line at www.qacoustics.co.uk/brochures.
5
Publicité
Table des Matières
