Different Configurations - Robot Coupe J80 Ultra Notice D'instruction

DIFFERENT
CONFIGURATIONS
The J 100 Ultra juicer comes supplied with all the
accessories you will need and is designed to adapt
itself to your particular needs and work setting.
For example, it can be configured to suit the cha-
racteristics of your work station:
• Install the booster base 10 if you are going to use
tall containers to collect the juice (see page 9).
• In normal usage, you can process more than ten
kilos (according to the nature of the produce)
before you need to empty the pulp container 6
(see page 9).
• For high-volume juicing, the ejection chute 7 (see
page 9) does away with the need to empty the
pulp container. If you opt for this configuration,
make sure you place a large bin (not supplied) di-
rectly below the chute.
There are two solutions for this configuration:
1) Make a 4-inch Ø hole in the worktop through
which the ejection chute 7 can protrude (see
photos opposite). This is the best solution in
terms of efficient worktop organization.
2) Worktop edge.
When positioning the machine on the edge of
the worktop, use the markers on either side of
the booster base 10 (see page 9) as your
guide.
Warning:
to avoid the risk of the machine falling
off the worktop, make sure that it is correctly
positioned.
• Summary of all the different possible configurations, according to the nature of the work
station and the height of the juice containers (for information only):
Booster base 10
Container
use (see p. 9)
Not necessary
Containers
Max. height 6.3 inches
Necessary if
container more
than 6.3" high
Containers
Max. height 9.8 inches
Intensity of
Example of use
use
• With pulp container 6
(see p. 9)
Normal
• No worktop cutout required.
• With ejection chute 7 and
strap 9 (see p. 9)
• Worktop edge
No cutout required
Intensive
• With ejection chute 7
(see p. 9)
• Ejection below worktop.
4-inch hole required in
worktop.
• With pulp container 6
(see p. 9)
Normal
• No worktop cutout required.
• With ejection chute 7 and
strap 9 (see p. 9)
• Worktop edge
No cutout required
Intensive
• With ejection chute 7
(see p. 9)
• Ejection below worktop.
4-inch Ø hole required in
worktop.
11