Pleasant Hearth 24-900-002 Directives D'installation Et D'utilisation page 12

OPERATING INSTRUCTION
1 Main Power Button:
This button supplies power to all the functions of the
fireplace. The main power button must be in the ON position,
either from the remote or on the touch pad for the functions
to work.
Timer Button:
2
This button controls the timer ON/OFF and 10-time setting
from 30 minutes to 9 hours. When the Timer is first turned
on, it will come on at the shortest time setting (30 minutes).
Each time the Timer button is pressed, the time increases 1
hour, up to the longest setting (9 hours). Once the set time
expires, all fireplace functions will be automatically turned off.
3 Flame Control button:
This button controls the brightness of the flame effect with
settings at High, Medium and Low. When the fireplace is first
turned on, the flame will come on at the highest setting. The
fireplace will remember the last flame setting used and in
later use the flame brightness will start at that setting, unless
power to the unit has been interrupted. Each time the Flame
button is pressed, the flame brightness decreases. The only
way to turn off the flame effect completely is to turn off the
Main Power button.
Heater Control Button:
4
This button controls the heater ON/OFF and 11 temperature
modes from 68°F (20°C) to 88°F (31°C). When the heater is
first turned on, it will come on at the lowest room temperature
setting 68°F (20°C). Each time the Heater Control button
is pressed, the temperature set point increases 2°F (1°C),
allowing you to adjust the ambient temperature, up to 88°F
(31°C). The fireplace will remember the last heat setting, and
in later use, the heater will start at that setting, unless power
to the unit has been interrupted.
NOTE: To switch between Fahrenheit/Celsius modes see
control panel Fahrenheit/Celsius display instructions.
12
Figure 6
1
2
3
4