Pleasant Hearth 24-900-002 Directives D'installation Et D'utilisation page 10

OPERATING INSTRUCTION
The fireplace control functions can be accessed in two (2) ways:
• Using the touchpad control panel, located in the upper right-hand corner of the fireplace
behind the sliding control panel cover.
• Using the multifunction remote control unit.
The fireplace features conveniently separate controls for flame effect and for heater control.
This allows you to operate the unit in two (2) different modes:
• As a full-featured fireplace - both flame effect and heater are on.This mode allows you to enjoy
the look of the fire along with the heat output of a heater.
• As a visual effect - only the flame effect is on, the heater is off. We recommend this mode for
warm weather application, when you want the ambiance of a fire, without any heat output.
Figure 4
5
1
Main Power Button:
This button supplies power to all the functions of the fireplace. The Main Power button must be
in the ON position, either from the remote or on the touch pad for the functions to work.
2 Down Light Button: (MODEL 28" only)
This button controls the interior brightness. Turning the down light button on illuminates the
interior of the firebox.
Heater Control Button:
3
This button controls the heater ON/OFF and 11 temperature modes from 68°F (20°C) to 88°F
(31°C). When the heater is first turned on, it will come on at the lowest room temperature setting
68°F (20°C). Each time the Heater Control button is pressed, the temperature set point increases
2°F (1°C), allowing you to adjust the ambient temperature, up to 88°F (31°C). The fireplace will
remember the last heat setting, and in later use, the heater will start at that setting, unless power
to the unit has been interrupted.
4
Flame Control button:
This button controls the brightness of the flame effect with settings at High, Medium and Low.
When the fireplace is first turned on, the flame will come on at the highest setting. The fireplace
will remember the last flame setting used and in later use the flame brightness will start at that
setting, unless power to the unit has been interrupted. Each time the Flame button is pressed, the
flame brightness decreases. The only way to turn off the flame effect completely is to turn off the
Main Power button.
4 3 2 1
10
7 6