Relay Mode Setup; Turning Off Relay Mode - PocketWizard Plus II Manuel Du Propriétaire

Relay Mode Setup

1. Set the master triggering PocketWizard
(the one in your hands) to Channel 1.
2. Set the Plus II Transceiver (the one for your remote
camera) to Channel 1 and set TRANSMIT MODE to BOTH.
3. Connect the Plus II Transceiver's CAMERA / FLASH port to
the motor drive port of the camera.
4. Slide the Plus II Transceiver into your camera's hot shoe.
5. Set the PocketWizard for your remote flash to Channel 2.
6. Connect your remote flash to its PocketWizard normally.
7. Turn everything on, then press and release TEST on the
PocketWizard in your hands to begin the sequence.
If you are using a camera with no hot shoe, or the hot shoe cannot be used, then
connect the Plus II in this manner: Connect the camera's motor drive cable to the FLASH
port. Connect the camera's PC sync terminal to the CAMERA / FLASH port.
You can use different channels to perform the relay function. The
master triggering PocketWizard (usually the one held in your hand)
and the Plus II Transceiver connected to your remote camera need
to be on the same channel. The PocketWizard connected to your
remote flash needs to be set one channel higher.
If master trigger
PocketWizard is set to:

Turning Off Relay Mode

If you want to trigger a remote camera and have the Plus II mounted in the
camera's hot shoe, but you do not want the relay sequence to happen, simply
set the TRANSMIT MODE switch to LOCAL on the unit in the camera's shoe.
ee NOTE 5 for more information on relay triggering.
S
Set the remote camera's
1
2
3
4
Plus II Transceiver to:
1
2
3
4
Using Hot Shoe
Without Hot Shoe
Set the remote flash's
PocketWizard to:
2
3
4
1