Product Description; Torque Adjustment - Cooper Tools Cleco 30PTHL353 Mode D'emploi

30/35PTH
2. P D
RODUCT ESCRIPTION
The pulse nutsetter features
- torque shut-off,
- alternative air inlet on top. If the top air inlet is used the screwed
plug <13> must be screwed and sealed in the air inlet on the pistol
grip.
- trigger-start with soft-start valve,
- available with two different pistol grip sizes,
- has a lockable torque adjustment accessible from the outside
- reversible, RH and LH operation,
- generates less than 72 dB(A) when idling,
- generates less than 2.5 m/s² vibration when pulsing
3. T A
ORQUE DJUSTMENT
Separate the tool from the air supply.
- Square drive model: prevent turning of hydraulic rotor <73> by
using a wrench size 10 (3/8").
- Quick-change model: prevent turning of the hydraulic rotor <118>
by holding the sleeve <142>.
- Turn valve screw <87>/<132> with a screwdriver size 3
counterclockwise gently until stop is reached (minimum torque
setting).
- With about 0 - 4 turns clockwise, set the desired torque (17-35 Nm).
- If pulse rate < 4 free speed should be reduced by turning exhaust
air throttle <7>. Set bolt <10> must be loosened with wrench size
2 first.
- Turn exhaust air throttle in direction "-", speed will be reduced.
Torque setting
by means of valve screw <87>/<132>
(key size 3; Order-No. 913947)
Speed setting
by means of exhaust ait throttle <7>:
If pulse rate < 4 reduce free speed
Free speed not lower than 2800 r.p.m.
Sample adjustment:
1. Bolt M8 8.8 = 25 Nm
2. Torque adjustment about 2 turns of valve screw
<..>/<..> = see 7. Spare Parts Ordering List
<..> Spare parts index for the
8
Caution!
4. I
To prevent downtime, regularly
- check the oil level of the pulse unit,
- regularly replace the oil level of the pulse unit <90>/<135> every 500
operating hours or at least every 12 months, the set of seals <146>
must be replaced.
5. W
...the torque is too low?
-
-
-
-
-
-
Set bolt <10>
(key size 2; Order-No. 920001)
3/8" version /<..> Spare parts index for the
P1622E 01/01
Do not reduce the speed below 2800 ¹/min, as the idling
speed can then become unsteady.
M
NSPECTION AND AINTENANCE
D I ...
HAT TO O F
Is the throttle exhaust adjusted correctly?
Is the flow pressure too low?
Is the reverse button not in one of its end positions?
Is the inlet screen dirty?
Is the muffler dirty?
Is sufficient oil in the pulse unit?
Turns of valve screw <87> / <132>
1/4" version