CLAS OE 2060 Mode D'emploi page 17

RECHARGEABLE IMPACT WRENCH 1/2" 600Nm
OE 2060 - OE 2065
OVERLOAD PROTECTION AND OTHER SAFETY FEATURES
The machine/battery pack has a number of safety features that prevent damage to the machine and battery pack
during use.
• During short high-load situations the overload protection may turn off the machine/ battery pack. This protection
resets automatically. Release the trigger, wait a few seconds, ensure that there is no load and restart the machine.
The machine should now function normally again.
• During high-load for extended periods the overheating protection may turn off the machine/battery pack. The
protection resets itself but the machine cannot be restarted until it has returned to normal operating temperature. Let
the machine cool properly before trying to restart it. Adverse temperatures can occur in direct sunlight and should
therefore be avoided.
• The battery pack has low-voltage protection which comes into effect when the batteries becomes discharged.
The low-voltage protection turns off the machine automatically and the battery pack should be recharged.
Maintenance & cleaning
Maintenance
The contacts on the battery pack and the charger must be kept clean. All replacement parts must be replaced by
a trained electrician or an authorized service centre unless stated otherwise in this manual
Cleaning
Clean the battery charger housing using a soft, dry cloth. Disconnect the charger from the mains before cleaning.
Remove the battery before cleaning the battery charger.
Ensure that the ventilation slots are not blocked.
The contacts on the battery pack and the charger must be kept clean.
ENVIRONMENT
Should your appliance need replacement after extended use, do not discard it with the household rubbish but
dispose of it in an environmentally safe way.
Waste produced by electrical machine items should not be handled like normal household rubbish. Please recycle
where recycle facilities exist. Check with your Local Authority or retailer for recycling advice.