Important - ATI SOL-GP Manuel D'instructions


total hardness: between 15 and 30 °F; in the presence of water with a hardness higher than
30 ° F it is recommended to use anti-limescale devices or softeners (the choice must be
made based on the characteristics of the water).
In the presence of water with parameters that do not comply with the above, the manufacturer
reserves the right not to recognize the warranty.
USE
4.
Lift and rotate the mixer handle (FIG-4-1) until the desired water temperature is reached (A:
hot water position – B: cold water position).
Once the mixer is open, the water takes about 15/20 seconds before coming out of the shower head
as it is necessary to wait for the push given by the pressure of the network.
At the end of the use, return the handle to the initial position to stop the water supply. The water will
continue to flow out of the shower head until the thrust previously given by the mains pressure is
exhausted (about 30 seconds).
Warning, danger of burns: always start using the shower with the mixer knob positioned in
cold water position as the temperature inside the shower can reach temperatures above 50 ° C.
Attention: if the shower is not used for more than 3 days it is advisable, before use, to let the
water flow out for about 2 minutes to remove the stagnant water inside the shower
The foot wash tap only delivers cold water
MAINTENANCE
5.
Shower cleaning: use specific products for satin stainless steel and non-rough cloths, taking
care to clean following the direction of the veins to avoid damaging the surface. Avoid using abrasive
sponges and steel wool, or water that is very hard, dirty or full of debris. Avoid using chlorine-based
detergents (e.g. bleach).
Disassembly at the end of the season: the shower is not suitable for withstanding frost. At the
end of the summer season it is necessary to empty it completely and store it in a covered place
sheltered from the elements.
To empty the shower, lift and turn the mixer knob to the cold water position, then disconnect
the cold water inlet and wait for the shower to empty completely
Failure to empty during the winter season can cause the tank to break due to frost. Do not
use salt or other antifreeze methods.
IMPORTANT: if the appliance remains unused for a long time, it is advisable to protect it with
the protection bag from dirt and atmospheric agents. In summer, in particular if the appliance is
empty, it avoids the reaching of high temperatures inside the tank that might deform it.
Pag. 11 / 32
ENGLISH
210-0275 – edizione 2021-04