Charging Procedure - Worx WA3845 Manuel D'instructions

SYMBOLS
Read the operator's manual
Warning
For indoor use only
Double insulation
Waste electrical products must
not be disposed of with household
waste. Please recycle where
facilities exist. Check with your
local authorities or retailer for
recycling advice.
T2A
Fuse
6
Positive terminal
Negative terminal
Battery charger

CHARGING PROCEDURE

NOTE: Before using the tool, read the
instruction book carefully.
CHARGING INSTRUCTIONS
1. CHARGING YOUR BATTERY PACK
WARNING: The charger and battery
pack are specifically designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because an electrical failure and hazard will
occur.
2. BEFORE USING YOUR CORDLESS
TOOL
Your battery pack is UNCHARGED and you
must charge once before use.
3. HOW TO CHARGE YOUR BATTERY
CHARGING PROCEDURE
1) Plug the charger into an appropriate
outlet. The light will be green.
2) Insert the battery pack into the charger, the
light will be red to indicate the charging
process has started.
3) On completion of charge, the light will turn
to be green. The pack is now fully charged,
unplug the charger and remove the battery
pack.
WARNING: When battery charge
runs out after continuously use or
exposure to direct sunlight or heat, allow
time for the tool to cool down before re-
charging to achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect some
problems that can arise with battery packs.
Indicator lights indicate problems (see table
below). If this occurs, insert a new battery pack
to determine if the charger is OK. If the new
battery charges correctly, then the original
pack is defective and should be returned to a
service center or recycling service center. If the
new battery pack displays the same problem
as the original Battery Pack, have the charger
tested at an authorized service center.
EN