Problem Solution; Environmental Protection - Worx WA3845 Manuel D'instructions

4. TO REMOVE OR INSTALL BATTERY
PACK
Locate latches on side of battery pack and
depress both sides to release battery pack
from your tool. Remove battery pack from
your tool. After recharge insert the battery
pack into the battery port. A simple push and
slight pressure will be sufficient.

PROBLEM SOLUTION

1. I CANNOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
a) Check if the charger and the battery pack
are specifically designed for working
together.
b) The battery can be inserted into the
charger only in one direction. Turn the
battery around until it can be inserted into
the slot, the indicator light should be red
when the battery is charging.
2. REASONS FOR DIFFERENT CHARGING
TIMES
The charging time can be affected by many
reasons which are not defects in your product.
8
a) If the battery pack is only partly discharged
it may be re-charged in less than 1 hour.
b) If the battery pack and ambient
temperature are very cold then re-charging
may take 1-1.5 hours.
c) If the battery pack is very hot it will not re-
charge because the internal temperature
safety cutout will prevent it. If the battery
pack is very hot you must remove your
battery pack from the charger and allow
your battery pack to cool first to ambient
temperature and then recharging can be
started.
Battery charger
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication
or maintenance. Never use water or chemical
cleaners to clean your tool. Wipe clean with
a dry cloth. Always store your tool in a dry
place.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be
disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.
EN