Menu For Speed Limit; Menu For Setting; Error Code - e-TWOW BOOSTER PLUS Mode D'emploi

Menu for speed limit

a. To set up a
detailed below:
- Turn off the display
- Press and hold the thumb brake.
during the entire operation
- Power the display
The display will show "L1"
b. Move to the option you want by
pressing the [LIGHT] button:
[LIGHT] L1-L2-L3-L4-L5
- To set up and save the speed limit
you want, press the S - [SET] button
- To finish the settings, release thumb
brake and turn on the scooter
Menu for settings
a. To set up one of this
detailed below:
- Turn on the
- Press and hold
during the entire operation
- Press the [POWER]
The display will show: P1
b. Move to the option you want by
pressing the [LIGHT] button:
- To set up and save the option you
want, press the S - [SET] button
- To finish the settings, release
* – If you want to stop the scooter while this function is activated, please use the
thumb electric brake.
** – Turns off the acceleration so that both handles become regenerative brake
handles
When this option is activated, the scooter can be used as a normal kick scooter,
but with 2 regenerative brakes.

ERROR CODE

E1 – Overcurrent protection (Motor does not move
more than 4 seconds) - this error clears after release the
acceleration throttle
E2 – Communication error (No communication for
ELECTRIC TWO WHEELS
A NEW ERA IN URBAN MOBILITY
speed limit, please follow the steps
options, please follow the steps
display
the thumb brake. Keep it pressed
button
P1- P2*- P3**
is released.
Keep it pressed
L1 = Limit the speed to 6 km/h
L2 = Limit the speed to 12 km/h
L3 = Limit the speed to 20 km/h
L4 = Limit the speed to 25 km/h
L5 = Limit the speed to 30 km/h
P1 = Zero Start [ON/OFF]
P2* = Cruise Control [ON/OFF]
P3** =
the thumb brake.
10
Zero acceleration
for
[ON/OFF]