Faqs - Chamberlain KLIK2U Mode D'emploi

FAQs

Why won't my keypad work?
• Did the keypad lights come on when you entered your PIN? If the keypad
lights do not turn on when you press a button, it indicates that the battery
needs to be replaced. Replace with a 9V battery.
• Try reprogramming the keypad to the garage door opener.
• Make sure the keypad is compatible with your garage door opener
(Chamberlain 315 MHz or 390 MHz garage door openers manufactured after
January 1, 1993).
• If the solutions above did not work, replace the keypad.
How do I erase my pin?
To clear out the keypad, press and hold the * and the # keys together until the
keypad stops flashing. Proceed to reprogram the keyless entry.
Can I program the keypad to a second garage door opener?
The keypad can only activate one garage door opener.
WARRANTY
ONE YEAR LIMITED WARRANTY
The Chamberlain Group, Inc. warrants to the first consumer purchaser of this
product that it is free from defect in materials and/or workmanship for a period
of 1 year from the date of purchase.
114A5072
Do I always have to use a 0 after my 4 digit PIN to activate the opener?
After programming the keypad, any fifth number will act as the "enter" button
to activate the opener.
Why does the door move after I only press 1 number button?
After operating the garage door with the keypad, the keypad lights will flash for
10 seconds. The keypad remains active during the 10 seconds of flashing; any
number will activate the door.
Where is my LEARN button located?
If equipped with a LEARN button, it can either be found on the garage door
opener or on an external receiver. To locate the receiver look for an antenna.
Some receivers will require a cover be removed to gain access to the
switch positions.
Will I have to reprogram the keypad after changing the battery?
The keypad should retain its memory. If the keypad no longer operates the
operator, reprogram the keypad to your system.
Where is my LEARN button on my gate?
Most gate operators have a built-in radio receiver or an external receiver. The
receiver on a gate opener can usually be found within the cabinet of the
operator. To gain access you might require permission if used in a
community gate.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications
of this receiver and/or transmitter are prohibited, except for changing the code setting or
replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards for Home or office use. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired
operation.
www.chamberlain.com
© 2007, The Chamberlain Group
9
1-800-442-1255
All Rights Reserved