Chamberlain KLIK2U Mode D'emploi page 7

Programming
TYPE 5
Genie Intellicode 2 garage door openers
with: Program/Set button.
1 Select and write a 4-digit PIN:
__ __ __ __
Press and hold the * and
2
until keypad stops flashing.
Enter PIN from step 1, press #.
3
Press 5, then press #.
4
On the garage door opener, press
5
and hold the Program/Set button
until both the long and short LED
light up BLUE.
Release the Program/Set button and
6
only the round LED will be lit in
BLUE.
Opener
# buttons
Press and release the Program/Set
7
button and the long LED will flash
PURPLE.
®
On the Genie remote control,
8
press and release the button that is
already programmed to the garage
door opener. Both LEDs will flash
PURPLE.
®
On the CLICKER keypad, enter
9
the PIN from step 1, and press
and release the 0 key. Both LEDs
on the garage door opener will
light up PURPLE.
On the CLICKER ® keypad, press
10
and release 0 again. Both LEDs on
the garage door opener will light
up BLUE.
11 On the CLICKER ® keypad,
press and release 0 again.
This will activate the garage
door opener and
programming is complete.
To test and use, wait 30 seconds, then enter
12
your PIN and press the
If opener does not function, repeat programming.
7
0 key.