Using Appliance - Telefunken VCBH5 Mode D'emploi

Using appliance

 Place the product in an upright position on a flat, steady, stable, heat-resistant surface. Make
sure there is nothing flammable or heat sensitive within 1 meter. Operating the product in
any other position could cause a hazard.
 Take out the power cord from its storage, and insert the main plug into a socket. Press the
power switch (red color) to position I. Always ensure the main cable is fully unwind and
outside of the cable storage when the product is in use.
 Press the power button (
at this setting, the heater will be at max. power continuously.
 Press the button I/II to switch on lower power ( ) in continuous run. If let at this setting,
the heater will be at low power continuously.
1. Setting the temperature
 Press the MODE button until the temperature icon blinks.
 Use the "+" and "-" button to set the desired temperature.
 The temperature icon will stop blinking and the current ambient temperature will appear
after the desired temperature is set.
 The heater will turn-off shortly after the room temperature is higher than the desired
temperature. The temperature display will blink.
 The heater will turn back on when the room temperature drops below the desired
temperature. The temperature display will then stop blinking and keep displaying the
room temperature.
Note: The LCD display shows the ambient temperature near the heater, to achieve optimal indoor temperature,
it is advisable to increase the target temperature during the first hour of use of the device, then you can adjusting
the temperature.
2. Set the timer in Auto shut off (AUTO OFF)
The hour display and Auto Off icon will appear.
Use the "+" and "-" button to set the heater operation time between 1 and 24 hours. This
function will activate once the timer icon stops blinking. The heater will automatically turn-off
when time runs out.
) to switch on heater at max. power (
This function should only be set if you desire that the heater
be automatically shut off after a certain period of time (1 to
24 hours from the time the function is set). Always set the
desired temperature prior to setting the Timer so that the
heater will shut off at the desired temperature setting.
Press the MODE button until the timer icon blinks (
4
ENGLISH
) in continuous run. If let
).