Suzuki 990D0-44H00-ALM Instructions De Montage page 3

2. Connections
a) Run the alarm harness under the frame tube to the outside (picture 4-B), for easier operation dismount
the screw fixing the inner fender (picture 4-A).
b) Identify the 4-pin connector (picture 1-B) of the alarm system prearrangement, remove the counterpart
and insert the corresponding harness connector.
c) Identify the 1-pin connector (picture 1-C) (+12V) and insert the harness counterpart.
d) Run the alarm harness under the frame tube back inside.
e) Turn Indicator (right): identify and disconnect the 2-pin connector (picture 1-D), interpose the harness
counterparts.
f) Turn Indicator (left): identify and disconnect the 2-pin connector (picture 3), interpose the harness
counterparts.
g) Place the fuse housing as indicated in picture 5.
h) LED: place the LED on the right bike fairing (picture 6) and link the 2-pin connector to the harness
counterpart.
i) Connect the negative battery pole again.
j) Secure the harness with the tie raps.
k) Check and test the system (point 3.)
3. System check and test
a) To arm the system push once BUTTON 1 of the remote control.
Arming is confirmed by:
• Turn indicators flash two times (right-left-right-left)
•
2 acoustic signals (bleep)
•
LED turns on (quick flash)
The system is operating after 40 sec. «Standby Time»: the motorbike cannot start
b) Move the motorbike to test that movement sensor is operating
during 30 sec.
c) At the end of the alarm phase the LED is steady ON.
d) To disarm the system push BUTTON 1 of the remote control
Disarming is confirmed by:
•
Turn indicators flash once (right-left)
•
1 acoustic signal
LED gives 1 flash every 5 sec. to confirm an alarm due to a position variation
impulse (ON-OFF) on the ignition key.
e) To activate the PANIC alarm push once BUTTON 2 of the remote control
are flashing during 30 sec. (to stop this test push or BUTTON 1 or BUTTON 2).
f) Re-assemble the parts previously removed
WARNING: Handle screws must be locked by a torque wrench (23 Nm). Apply some thread locking.
g) End of installation.
4. What to be done before delivering the motorbike to its owner
a) Deliver to the owner the two remotes control together with the metal plate where the releasing emergency
"PIN CODE" is printed.
b) Explain to the owner the releasing emergency procedure
SUZUKI GENUINE ACCESSORIES
Led flashes slowly
siren sounds and turn indicators are flashing
to reset the alarm memory give an
the siren sounds and turn indicators
3