Operations Guide - Absaar AB3400 Mode D'emploi

12. Operation Guide
1) When properly connected to DC outlet or battery,
Open the inverter ON / OFF, will illuminate the green
POWER light, and deliver AC power to the outlets
2) Connect the AC load equipment
3) Open the AC load equipment switch.
If the connection is more devices, one should open and
the opened first start power larger equipment.
4) When the battery power fast used up, the battery
voltage began to fall, when the voltage to reduce the set,
inverter would automatically shut off, red failure indicator
light.
5) If AC load power rating of the inverter power greater
than the continuous power, inverter would automatically
shut off, red failure indicator light.
6) If inverter no adequate ventilation or environmental
temperature is too high, inverter, more than the safe
operation of the temperature, then inverter would
automatically shut off, red failure indicator light.
7) If a defective batteries charging system cause the
battery voltage arrived at risk of high potential, inverter
would automatically shut off, Red failure indicator light.
8) Battery Operating Time
Operating time will vary depending on the charge level
of the battery, its capacity and the power level drawn by
the particular AC load.
When using a vehicle battery as a power source，it is
strongly recommended to start the vehicle every hour or
two to recharge the battery before its capacity drops too
low, The inverter can operate while the engine is
running, but the normal voltage drop that occurs during
24