Absaar AB3400 Mode D'emploi page 23

switch is OFF.
2）Attach the ring type connector marked with red to the
positive (+) DC terminal on the inverter and attach the
ring connector marked with black to the negative (-) DC
terminal.
Caution! A reverse polarity connection (positive to
negative) may damage the inverter。Damage caused
by a reverse polarity connection is not covered under
warranty.
3）Tighten the nut on each DC terminal by hand until it
is snug. Do not over tighten.
4）When the inverter is not in use, disconnect the DC
Cable-Clips from the battery.
23