WEBTEC HPM6000 Guide Rapide page 13

Quick start – measurements using sensors with sensor-ID functionality
Connecting CAN sensors (for measurement chains with IP64 protection)
A B
A Power supply connection
B Ports for CAN bus sensors
(CAN X, CAN Y)
Up to eight CAN sensors can be connected via the bus line to each CAN-bus sensor port
(CAN X, CAN Y). If more than one sensor is connected to a bus line then an additional Y
splitter must be used.
Max. total length of cable, from measuring instrument to terminating resistor:
100 metres. Remember to use a terminating resistor before the last CAN sen-
sor at the end of the line, as shown in the illustration.
C Connection cable
D Y splitter
C
D
E
F
E Terminating resistor
F CAN sensor
13