Fitting Storage Racks; Power Supply - Gamko MG Serie Mode D'emploi

1 Hook pin (1) in openings (2) of rails (C).
2 Push bottom part (B) towards side (A).
3 This causes pin (3) to slot into the next opening (4) in the rails.
4 Fit the other pins at the same height.
5 Place the storage rack (D) sliding the pins (5) in the openings (6)
• If this device cable is damaged it must be replaced with an original
cable supplied by the producer.
• In case of emergency: remove the plug lead from the socket.
• The socket should be within easy reach of the cabinet.
• Check for the correct power supply, referred to the information on
the type plate.
• Ensure that the plug lead cannot be trapped or snagged.
• If necessary the plug lead can be extended by a qualified electrician.
• We do not recommend the use of an extension lead.
Fluctuations in the power supply can cause damage, which
causes the cabinet to switch off. Gamko cannot be held
responsible for any consequential damage.
36
User Manual

Fitting storage racks

Power supply