Ego Power+ ST1530 Guide D'utilisation page 28

Install the new trimmer head
1. Position the flange removed in step
8 of the "Remove the trimmer
head" section onto the motor shaft
with the bulge facing away from the
base (Fig. 27).
2. Position the flange cover onto the
flange with its flat surface facing
outwards (Fig. 28).
3. Align the mounting hole in the new
spool base with the motor shaft and
mount the new spool base onto the
shaft (see Fig. 25).
4. Position the plain washer onto the
motor shaft (see Fig. 24).
5. Mount the nut onto the shaft and
pre-tighten it COUNTERCLOCKWISE
by hand.
6. Rotate the spool base to align the
slot in the flange with the hole in the
gear case (see Fig. 21).
7. Insert the hex wrench provided
into the aligned holes to act as
a stabilizer (see Fig. 22). Use the
multi-function wrench provided to
tighten it securely onto the shaft
(Fig. 29).
8. Position the spring into the spool base and press it in place (see Fig. 20).
9. With one hand holding the spool base, use the other hand to grasp the new spool
retainer and align the tabs on the new spool retainer with the holes in the spool
base. Use your palm to press and rotate the new spool retainer left and right until
the tabs lock with the spool base (see Figs. 17 & 18).
28
56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER — ST1530/ST1530-FC
27
Bulge facing away from the base
28
Flat surface facing outwards
29