Candy ONE DOOR Manuel D'instructions page 17

POSITIONING AND INSTALLING THE APPLIANCE
1. Once the appliance has been unpacked, check the main voltage is the same
as that indicated on the rating plate.
2. If the door opening direction is as required, go to Point 3. Otherwise,
reverse the position of the hinges. To do this, carefully place the on its back,
user spacers to prevent crushing the condenser pipes and damaging the
compressor unit.
2a Remove the lower hinge pin P.
2b Remove the lower hinge A and free the door.
2c Remove upper hinge B, and fit the hinge A to the opposite side.
2d Remove the bottom support L.
2e Refit the door and the hinge B one the left side.
2f Refit the bottom support L to the opposite side.
When installing the appliance, remember the following:
A Do not install it near to sources of heat such as heaters, radiators, cookers,
etc. or in direct sunlight.
B Make sure that during the automatic defrost, any water on the back wall of
the compartment runs into the drain channel.
C After the appliance has been placed in its final position, leave it for about at
least an hour before connecting it to the power supply.
D Make sure that the appliance is working properly before placing any food in
it.
WARNING: DO NOT INSTALL THE APPLIANCE NEAR TO ANY HEAT SOURCES
AND LEAVE A GAP OF AT LEAST 5 CM ABOVE IT.
INSTALLATION IN THE TALL UNIT HOUSING
The dimensions of the tall unit housing must be corresponded to those
reported in the figure.
3 insert the appliance in the housing against the side panel adjacent to the
opening.
3a adjust the foot until the top panel is not in contact with the unit, and
anchor the upper part of the appliance, using the screws supplied, in the pre-
drilled panel over the front fascia.
3b Anchor the bottom of the appliance to the wall of the unit using the special
brackets.
3c Fix the two bottom feet in the holes in the base of the unit.
3d where provided, apply the plastic joint gasket.
3e Anchor the part X with screws on the appliance door.
3f Fit the sliding part Y with screws, after adjusting the housing door.
17