Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
m
WARNING!
To avoid personal injury, wear ear
protectors when operating this unit. Wear a face mask or dust
mask in dusty locations.
Dry Vacuuming Mode
m
WARNING!
Make sure to assemble the cartridge
filter properly when using the equipment for dry vacuuming.
The use of incorrect filter will damage the unit and void the
warranty.
The cartridge filter should be pre-assembled on the filter cage.
If not, follow the instruction below to assemble the cartridge
filter.
1. Make sure the battery is removed from the compartment.
2. Unlock the powerhead by flipping up the latches on both
sides, and then lift up (Fig. 5).
3. Turn the powerhead upside down. Put the filter basket
onto the cartridge filter. Push down until the filter sits
securely. Insert the cartridge filter lock. Turn clockwise to
secure (Figs. 12 - 13).
Fig. 12
Powerhead
Fig. 13
Cartridge
filter lock
4. Before putting back the powerhead, assemble the dust
Cartridge
filter lock
Fig. 14
Cartridge filter
Paper
dust bag
Filter basket
5. Replace the powerhead. Lock the latches on both sides
6. With the hose and the preferred nozzle connected, insert
12
bag by inserting the air inlet tube into the hole on the dust
bag, as shown (Fig. 14).
NOTE: It's recommended to use the paper dust bag for
dry vacuuming. The paper dust bag will collect all debris
and make clean-up after vacuuming much easier.
Air inlet
tube
securely (Figs. 8 – 9).
the battery into the battery compartment, and press the
ON ( I ) side on the ON/OFF switch (Fig. 15).
Publicité
Table des Matières
