SNOWJOE SUNJOE 24V-WDV6000 Manuel D'utilisation page 10

7. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Charging a Hot or Cold Battery Pack
The green indicator light on the charger base indicates that the
battery pack temperature is outside the charging range. Once
the pack is within the acceptable range, normal charging will
take place and the red light will be continuous. Hot or cold
battery packs may take longer to charge.
Lithium-Ion Charging Status
Charger
Battery
Base
Pack
Indicator
Temperature
Light
Too hot Green
Normal range
Red
Too cold
Green
Assembly
m
WARNING!
To avoid serious personal injury, read and
understand all safety instructions provided.
m
WARNING!
Do not insert battery until assembly is
complete. Failure to comply could result in accidental starting
and possible serious personal injury.
m
WARNING!
Before performing any maintenance, make
sure the battery is removed from the tool. Failure to heed this
warning could result in serious personal injury.
m
WARNING!
To prevent personal injury, make sure the
switch is in the OFF position before attaching or removing the
suction hose.
Battery
Pack Charging
Indicator Status
Light
Flashing
Not charging
together
Flashing Normal
one by one charging
Flashing
Not charging
together
1. Unlock the powerhead by flipping up the latches on both
sides, and then lift up (Fig. 5).
Fig. 5
Latch lock
2. Remove all the contents from the tank.
3. Turn the dust tank upside down. Fit a caster into the
mounting as shown. Fix with provided screw. Do not
overtighten (Fig. 6).
Fig. 6
Caster
4. Repeat to assemble all the 5 casters on the bottom
(Fig. 7).
Fig. 7
NOTE: The assembly requires 5 screws. The 3 additional
screws are spares.
10
Latch lock
Screw