Cleaning The Debris Filter - Samsung WF218ANS Manuel D'utilisation

CLEANING THE DEBRIS FILTER

We recommend cleaning the debris filter when water does not drain well or the "ND" error message is
displayed.
1. Open the filter cover by pressing and pulling the handle of
the filter cover with your finger.
2. Unscrew the drain cap by turning it counter-
clockwise.
3. Hold the cap on the end of the drain tube and
slowly pull it out about 6inches (15cm) and
drain off all the water.
4. Remove the debris filter cap.
5. Wash any dirt or other material from the debris filter. Make sure
the drain pump propeller behind the debris filter is not blocked.
6. Replace the debris filter cap.
7. Replace the filter cover
8. Close up the opening of drain tube with cap.
9. Don't insert the drain tube in the hole
WF218ANS-02440D_EN.indd 17
Step 1 Step 2
Maintaining your washer _17
2008-05-08 ¿ÀÈÄ 5:08:29