Working And Use - lamber P550-ek Instructions D'emploi

First Section - FOR THE USER

WORKING AND USE

NOTE:
- When the objects to be washed present burnt crusts, or a long time is elapsed from cooking up to the
time of washing, it is necessary to make a previous softening in water at 50°C, by using an appropriate
softeningproducts;
- Never deep naked hands in detergent water;
- While the machine is running, never open the door too rapidly;
- Only use specific anti-frothing detergents.
OPERATION BEFORE WASHING
B
EFORE STARTING THE WORKING OPERATION BE
:
SURE THAT
- the cock is open;
- the filters and
their housings;
- the wash arm and the rinse arm are
pivot;
- brightener and washing powder dispenser
containers are loaded.
T :
HEN PROCEED
A
- Put the detergent directly into the tank, by
paying attention to distribute it uniformly
on the filters, the quantity being according to
supplier's instructions.
N.B. When using chlorinated detergent, it is
suggested to use an automatic dispenser; if
otherwise, brownish spots might appear on the
surfaces, because of chlorine reactions, if
powering the detergent directly in the tank.
B
- Place the objects in the basket minding to
previously remove all solid waste and fat.
N.B.: When the objects to be washed present
burnt crusts, or a long time is elapsed from
cooking up tothe time of washing, it is necessary
to make a previous softening in water at 50°C,
by using an appropriate softening product.
C
- Turn the machines on by wall switch and
push the switch "A" situated in Dis.1.
At this moment the thermometer display lights up
And the tank fills up. When the tank is full the
control lamp for cycle "2" lights up.
D
– Introduce the basket in the ware-washer.
The control lamp "E" will flash in case the door of
the dishwasher is open.
the overflow are in
free to
Before you start the cycle be sure that the control
lamp "D" is lightened. This means that the water
for the washing cycle and the rinsing water
temperature reached the ideal temperature for
working.
E
– Choose the washing period cycle and push
the button "B" between the following items:
- lamp 1 lightening – short cycle of 2 minutes
- lamp 2 lightening – medium cycle 3 minutes
- lamps 1 and 2 lightening at the same time
long cycle of 4 minutes.
The washing period cycle has to be chosen
regarding the dirt that has to be removed.
F –
Close the door of the ware-washer.
Push the button cycle "C"
The dishwasher starts the washing with the
period you chosen. Additional to this period will
be a pause of 5 seconds and a rinsing period of
23 seconds with clean water about 85° to 90°C.
The control cycle lamp is flashing up to the end of
the complete washing period. Finished the
washing period the control lamps will stop
lightening.
Only for machines with steam condenser!
At the end of the washing, the steam suction fan
starts running
continues for a time that can be programmed from
5 to 80 seconds after the rinse end (as default
20'').
For the programming, look at the specific
paragraph in the installer section.
Cycle lamps flash till the completion of the final
phase of steam ventilation/suction.
At the end of the cycle, the lamps stop flashing
and an acoustic signal, with a maximum duration
of one minute, informs that it is possible to open
the hood.
23
ENGLISH
automatically. The suction