Loading Label Roll In Tear-Off Mode - Valentin VITA II Guide De Référence Rapide

Loading label roll in tear-off mode


Open the printer cover.

Open printhead (G) by turning the red pressure lever (F) anticlockwise.

Remove the outside label mounting plate (A).

Load the label roll with inner winding onto the unwinding roll (B) and attach again the label mounting plate (A).

Lead the label material below the return pulley (C) and the printhead (G).
Pay attention that the label runs through the photocell (E).

In order to move the printhead (G) down, turn the red pressure lever (F) in clockwise direction until it locks.

In front of the printhead you can see the tear off (H) from which you can rip off labels to the bottom.

Enter the offset value in the menu Print settings/Tear-off.

Adjust the adjusting ring (D) of the return pulley (C) to the width of material.

Close the printer cover.
English
Vita II
91