Conrad 67 26 30 Mode D'emploi page 3

O P E R A T I N G I N S T R U C T I O N S
Dual Refrigerator and Freezer
Thermometer
Item no. 67 26 30
Intended Use
The dual refrigerator and and freezer thermometer enables you to ascertain and control the
temperature in your refrigerator and freezer compartment or freezer. The temperature is in-
fl uenced by the fi lling level and the ambient temperature and requires regular adjustment. By
making sure the cooling temperature is maintained at an optimal level, you both save electricity
and keep your food fresh for longer.
The device may be used only indoors. Contact with moisture, for example in bathrooms, must
be avoided.
The dual refrigerator and freezer thermometer may only be powered by battery. Do not use
any other power supply. The correct battery type is specifi ed in the "Technical Data" section.
Any use other than described above is not permitted and can damage the product. In addition,
it can lead to dangers such as short-circuit, fi re etc.
This product complies with the applicable National and European regulations.
All names of companies and products are the trademarks of the respective owner. All rights
reserved.
The safety instructions have to be followed without fail.
An exclamation mark inside a triangle indicates important instructions in the
operating manual.
☞
The "hand" symbol indicates special information and advice on operating the
device.
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe
these safety instructions! We do not assume any liability for damage to prop-
erty and injury to persons caused by mishandling or non-compliance with the
safety instructions! In such cases, the warranty will be null and void.
General safety instructions
• For safety and approval (CE) reasons, unauthorised conversion and/or modifi cation of the
product are not permitted.
• Do not expose the product to high temperatures, strong vibrations or heavy mechanical
loads.
• Handle the product with care, it can be damaged by impacts, blows, or accidental drops, even
from a low height.
• If you have any doubts about the correct operation, or the safety of the product, please con-
sult a specialist.
• Do not allow children to play with the device. Only use the product out of the reach of children.
Small parts of the product or the battery could be swallowed.
• Condensation may form when the product is brought from a cold room into a warm one. Wait
until it has reached room temperature before using it.
• Do not leave packaging materials unattended. They may become dangerous playthings for
children.
• Please observe the additional safety instructions in the individual chapters of this manual.
Battery Safety Information
- Ensure that the polarity is correct, when inserting the batteries.
- Remove the batteries, if you are not going to use the device for a while, to prevent damage
from leaking.
- Leaking or damaged batteries/rechargeable batteries can cause acid burns on contact
with the skin. Thus, you should wear protective gloves when handling damaged batteries/
rechargeable batteries.
- Do not leave batteries/rechargeable batteries lying around; they could be swallowed by chil-
dren or pets. If swallowed, consult a doctor immediately.
- Ensure that batteries/rechargeable batteries are not short-circuited or thrown into a fi re.
There is a risk of explosion!
- For the environmentally friendly disposal of batteries/rechargeable batteries, please read the
chapter "Disposal".
Inserting/Replacing the Batteries
www.conrad.com
• Open the cover of the battery compartment (11) on the back of the device.
• Insert two new 1.5V micro-batteries (AAA) in the battery compartment, paying attention to the
Version 02/12
polarity. The correct polarity is indicated in the battery compartment.
• Close the battery compartment (11) again.
• The thermometer will beep and the fi rst temperature value will be displayed.
• If the display contrast fades, the battery is low and has to be replaced as described above.
• The thermometer also has a battery status indicator (1).
• To ensure a long battery life, only use alkaline types.
☞
Set-up
- Flip the table stand (10) down.
- Place the thermometer on a fl at, level surface.
- The thermometer can also be attached to a metal surface using the magnet on the back.
Controls and Parts
MIN/MAX button (2)
°C/°F switch (9)
Functional Description
The dual refrigerator and freezer thermometer monitors the temperature of your refrigerator
or freezer. The internal temperature may be infl uenced by the fi lling level or the ambient tem-
perature. By ensuring that the cooling temperature is maintained at the optimal level, you both
save electricity and keep your food fresh for longer. The ideal temperature for a refrigerator
is between 4° - 8° degrees Celsius, depending on section (top, middle or bottom shelf). The
ideal temperature for a freezer compartment is -18° to -20° degrees Celsius. Settings which
are too cold consume unnecessary energy. Just setting the temperature of a freezer 1° degree
Celsius lower reduces energy consumption by 3%; for a refrigerator, by as much as 6%. As you
can easily read the temperature on the temperature gauge on the outside, you do not have to
open the refrigerator or freezer door regularly, which in turn prevents the temperature inside the
refrigerator or freezer from rising.
Getting Started
After inserting the batteries, proceed as follows:
- First, turn the switch (7) to the "off" position
- You may see a difference of ca. 0.5° degrees in the room temperature between the two
displays. This difference is the measuring tolerance.
- Position the thermometer near the refrigerator and freezer, so that the temperature sensors
reaches into the refrigerator and freezer. The length of the temperature sensor is ca. 138 cm.
- Open the refrigerator door and secure the temperature sensor for the refrigerator (12) -
marked "Fridge" - between the door and the inside of the refrigerator using the suction cup.
- Open the freezer door and secure the temperature sensor for the freezer (8) - marked "Freezer"
- between the door and the inside of the freezer, by using the suction cup.
- Make sure when attaching the suction cup that the intended location is clean and dry.
- If you wish to use the thermometer only for the refrigerator or only for the freezer, you simply
do not use the other thermometer.
The use of rechargeable batteries leads to a shorter operating time, because of the
lower voltage and capacity.
Battery status display (1)
Alarm and
Button "C" (3)
LED Alarm (5)
Refrigerator
display T1 (4)
Table stand (10)
Signal / LED or
OFF switch (7)
Freezer
display T2 (6)
Freezer
Temperature sensor (8)
Refrigerator
Temperature sensor (12)
Battery compartment (11)