Cleaning, Maintenance, Storage, Transport And Ordering Of Spare Parts - MX-PG D-PG 1000 Traduction Des Instructions Originales

9. Cleaning, maintenance, storage,
transport and ordering of spare parts
Switch off the motor and pull the spark plug boot
from the spark plug before doing any cleaning
and maintenance work on the equipment.
Important: Switch off the generator immediately
and contact your service station:
In the event of unusual vibrations or noise.
•
If the engine appears to be overloaded or
•
misfires.
9.1 Cleaning
Keep all safety generators, air vents and the
•
motor housing free of dirt and dust as far as
possible. Wipe the generator with a clean cloth or
blow it with compressed air at low pressure.
We recommend that you clean the generator
•
immediately each time you have finished using it.
Clean the generator regularly with a moist cloth
•
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the generator.
9.2 Air filter (Fig 6-7)
Clean the air filter at regular intervals, and
replace it if necessary. Please also read the service
information.
Remove the air filter cover (Item E).
•
Remove the air filter (Item G).
•
Clean the air filter by tapping it. In cases of
•
stubborn dirt first clean with soapy water,
then rinse with clear water and air-dry before
reinserting. Important: Do not use abrasive
cleaners or petrol to clean the air filter.
Assemble in reverse order.
•
9.3 Spark plug (Fig. 8-9)
Check the spark plug for wear at regular intervals.
Please also read the service information.
Pull off the spark plug boot (Item I) by twisting it.
•
Remove the spark plug (Item J) using the
•
supplied spark plug wrench.
Clean the spark plug with a copper wire brush or
•
fit a new one.
Assemble in reverse order.
•
9