Assembly Instructions For The Movement Sensor; Coverage Angle; Device Settings; Resetting To The Factory Settings - Schwaiger HG2000 Instructions De Service

USER MANUAL HG2000 532

5.2. Assembly instructions for the movement sensor

• This product is exclusively suited to use in indoor or covered (rooved) areas. No liability for subsequent defects
can be undertaken in the case of mounting in outdoor areas.
• It is recommended to mount the product in vulnerable areas or directly next to possible break-in points.
• Do not mount the movement sensor directly next to ovens, air-conditioning units or other similar types of
system.
• Select the place of mounting so that there are very few or no hindrances (e.g. furniture or cupboards) in what
will later be the coverage area.
• Before installation, check the suitability of the place of assembly and also check the mounting material. Ensure
that no electrical, water, gas or other connections are present at the mounting location.
• Depending on your mounting location, additional/other mounting accessories may be required for mounting.

Coverage angle

5.3. Mounting instructions for the door and window sensor with
magnetic contact
• It is recommended to affix the sensor unit directly on window or door frames and the magnetic contact directly
on the window or the door (moving part).
• This product is suited exclusively for use indoors. No liability for subsequent defects can be undertaken in the
case of mounting in outdoor areas.
• Please note that the markings on the device and the contact must be in a line and should be a maximum of 5
mm apart from each other, in order to ensure smooth functioning.
• The sensor can be mounted both on the left and on the right side.

6. DEVICE SETTINGS

6.1. Resetting to the factory settings

The entire system can be reset when needed.
To do this, press and hold the
LEARN
Then, by pressing the
again.
The ideal covera-
ge angle reaches
the product at an
assembly height
of 1.8 – 2.4 m.
LEARN button in the interior of the siren for 5 seconds.
button again, you get into the learn mode and can addition the remote controls
Reduction Enlargement
of the area of the area
15