Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
cut height. Otherwise, make narrower
cuts and mow slowly.
3) For best performance, keep the mower
housing free of built-up grass. From time
to time turn off mower and wait for the
blade to come to a complete stop. Then
unplug the Safety Key and turn mower on
its side. Using an object such as a stick,
wipe out any accumulation of grass in the
blade area. Be careful of the sharp edges
of the blade. Clean often in wet, new
grass, and always after every use.
4) Certain types of grass or grass conditions
may require that an area be mulched a
second time to fully disperse the grass
throughout the lawn. If cutting a second
time, it is advisable to cut perpendicular
(across) the first cut pattern. DO NOT
CHANGE CUT PATTERN IN ANY WAY THAT
WOULD CAUSE MOWING DOWN A HILL.
5) Change your cutting pattern from week to
week. This will help prevent matting and
graining of the lawn.
CUTTING AREA
The cutting area can be affected by many
factors including: cutting height, operation
practices (ex: starting/stopping), lawn
moisture levels, grass length and thickness.
The below table provides the potential cutting
areas based on specific cutting conditions.
Cutting Height
With 2*20V/4.0Ah batteries
Cutting off
3.3''(84mm) to
up to 5000 sq.ft. (460m
2.5''(64mm)
* Used with two fully charged battery packs.
TIPS:
1) Mowing the lawn frequently and
reducing the amount of starting/stopping
procedures will help conserve battery
runtime. It is recommended to always use
the same two batteries during operation
with fully charged levels.
2) For the best cutting performance, it is
2 in 1 Cordless Lawn Mower
Recommend lot size
(maximum)
2
) *
recommended to only mow up to 1/3 or
less of the current grass height at a time.
Mow at a slower pace when cutting long/
thick grass to allow the mower to properly
discharge the clippings.
MAINTENANCE
WARNING: Stop the mower and
remove the safety key before
removing the grass bag.
NOTE: To ensure long and reliable service,
perform the following maintenance
procedures regularly. Check for obvious
defects such as a loose, dislodged or a
damaged blade, loose fittings, and worn
or damaged components. Check that the
covers and guards are all undamaged and
are correctly attached to mower. Carry out
any necessary maintenance or repairs before
operating mower. If the mower should
happen to fail despite regular maintenance,
please call our customer helpline for advice.
BLADE SHARPENING
KEEP BLADE SHARP FOR BEST MOWER
PERFORMANCE.
WEAR PROPER EYE PROTECTION WHILE
REMOVING, SHARPENING, AND INSTALLING
BLADE. ENSURE THAT SAFETY KEY IS
REMOVED.
Sharpening the blade twice during a mowing
season is usually sufficient under normal
circumstances. Sand causes the blade to dull
quickly. If your lawn has sandy soil, more
frequent sharpening may be required.
REPLACE BENT OR DAMAGED BLADE
IMMEDIATELY.
WHEN SHARPENING THE BLADE:
1. Make sure blade remains balanced.
2. Sharpen blade at the original cutting angle.
3. Sharpen cutting edges on both ends of
blade, removing equal amounts of material
from both ends.
NOTE:
1. Be sure the mower is turned off and
remove the key.
2. Place the mower in stand up storage mode.
19
EN
Publicité
Table des Matières
