Assembly And Operation - Worx WG779 Mode D'emploi

OPERATION INSTRUCTION
NOTE: Read instruction handbook
before operation this machine.

ASSEMBLY AND OPERATION

ACTION
ASSEMBLY
Assembling the handle bar
NOTE: Choose one of the two
holes in the lower handle for
desired handle's height.
Assembling grass collection bag
Fitting grass collection bag to
the lawn mower
NOTE: Depress the grass
collection bag slightly to ensure
that it is completely installed.
NOTE: Take the mulching insert
out of the lawn mower before
fitting the grass collection bag.
Checking the battery charge
condition
NOTE: Fig. D1 only applies for
the battery pack with battery
indicator light.
Charging the battery pack
NOTE: The batteries are shipped
uncharged. Each battery must be
fully charged before the first mow.
Always fully charge the two
batteries at same time. More
details can be found in charger's
manual.
Fitting/removing battery
NOTE: This machine will only
run when 2 batteries are
installed. Please always use
two batteries with the same
capacity and fully charge the
two batteries.
Using two different sized
batteries or if one battery
isn't fully charged then the
machine will only run to the
lowest common denominator.
2 in 1 Cordless Lawn Mower
OPERATION
Battery power indicator on the
machine
See details in BATTERY STATUS
part
IMPORTANT
When only one light is illuminated,
at least one battery is depleted and
FIGURE
needs to be charged, even though
the mower may still be capable
of cutting grass. Continuing to
See Fig. A1,
operate your lawnmower with
A2, A3, A4,
the battery in this discharged
A5
condition may reduce the life and
performance of your battery.
See Fig. B1,
When no light is illuminated,
B2, B3, B4
at least one battery is not fully
installed or battery may be
defective, please double check
the batteries are fully seated into
See Fig. C1,
position.
C2, C3
Starting & stopping
Adjusting the cutting height
See Fig. D1
the motor stops before adjusting
height. The blades continue
to rotate after the machine is
switched off, a rotating blade
can cause injury. Do not touch
rotating blades.
See Fig. D2
Selecting the intellicut dial
ECO mode
Select ECO mode when
mowing in everyday conditions,
removing approximately 1'' of
grass at a time.
TURBO mode
Set the dial to TURBO mode
when cutting dense or
overgrown grass.
See Fig. E
WARNING! Stop, release
switch lever and wait until
See Fig. F
See Fig. G1,
G2
17
See Fig. H
See Fig.
I1, I2
EN