Table des Matières
Publicité
ASSEMBLY INSTRUCTIONS
STEP 4: Reflector Assembly
1. Align the 3 pcs of partial reflectors and
form a complete reflector as shown. Align
the holes on each piece with the
corresponding holes on the opposite
piece and fasten using Screw set F
Attention: The top edges of the 3 partial
reflectors must be overlapped to align correctly
with the reflector connecting plate (as shown
on the left). Hence, the top edges of the 3 partial
reflectors will need to be properly aligned before
proceeding to STEP 5.
9
Publicité
Table des Matières
