Audio Connections - Prodipe IEM7120 Manuel Utilisateur

Audio connections

Connect the audio source (mixing desk, front mix, etc.) to the XLR/Jack inputs on the IEM7120 transmitter.
An attenuation level of -12dB has been set (at the rear of the device) to reduce the considerable input level
from certain decks. Next adjust the level using the "INPUT LEVEL" knob at the front of the device.
Only one mono input can be used. See instructions on page 8 on how to set your transmitter to mono.
Connect one end of the mains adaptor to the dc input socket at the rear of the receiver and the other end
to a standard power outlet (230V/50Hz).
A 6.35mm audio output Jack is located alongside the "VOLUME" knob at the front of the transmitter. It
controls the signal sent by the transmitter.
Connect the Prodipe earphones to the 3.5mm output Jack on the bodypack receiver. Use the knob to adjust
the volume.
Two rack ears have been provided to ensure that the IEM7120 transmitter can be rack mounted into a
single 19" rack unit.
Illustrations et photos non contractuelles
Actual product(s) may differ from illustrations/photographs used
Copyright © 2017 IPE Music/Prodipe
Page 23