Audio Connections - Prodipe IEM5120 Manuel Utilisateur

Audio connections

Connect the audio source (mixing desk, front mix, etc.) to the XLR/Jack inputs on the IEM5120 transmitter.
Next adjust the level using the "Left" and 'Right" level's knob at the rear of the device.
Connect one end of the mains adaptor to the dc input socket at the rear of the receiver and the other end
to a standard power outlet (230V/50Hz).
A 6.35mm audio output Jack is located alongside the "VOLUME" knob at the front of the transmitter. It
controls the signal sent by the transmitter.
Connect the Prodipe IEM3 earphones to the 3.5mm output Jack on the bodypack receiver. Use the knob to
adjust the volume.
Illustrations et photos non contractuelles
Actual product(s) may differ from illustrations/photographs used
Copyright © 2020 IPE Music/Prodipe
Page 21